TroubleshootingSpecifications

Information Additional

If you experience any of the following difficulties while using the player, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer.

There is no sound.,Check that the player is connected securely.,Make sure you operate the amplifier correctly.,When you use the headphones, adjust the volume with PHONE LEVEL.There is no sound from the DIGITAL (CD) OUT connectors.

,The audio signals of the super audio CD cannot be output from the DIGITAL (CD) OUT connectors.

,The digital out mode is set to off. Set the digital mode to on (see page 22).The disc does not play.,There is no disc inside the player.,The disc is placed upside down on the tray.,Place the disc on the disc tray with the label side up.,The disc is placed at an angle. Reload the disc.,Clean the disc (see page 27).

,Moisture has condensed inside the player. Remove the disc and leave the player turned on for about an hour.

,There is an incompatible disc on the tray (see page 13).The remote does not function.,Remove any obstacles in the path of the remote and the player.,Point the remote at the remote sensor on the player.,If the batteries in the remote are weak, replace with new ones.If there is no sound only during 2 channel playback of a Super Audio CD.

,Check which mode is selected in Multi-channel management function of Super Audio CD (2 channel).

When the “2CH+ SW” mode is selected, sound is output through the 5.1 CH OUT jacks.

For details, see page 23.There is no sound from the SUB WOOFER jack.,Select the playback mode so that the Sub woofer is set to “a” (page 23).

,When you play a track that does not contain the LFE signal, the signal outputs from the SUB WOOFER jack only when you select “5 – Small + SW” or “FRT – Large + SW” for the Multi-channel playback mode (page 24).

SCD-XA777ES

When a super audio CD is played
Playing frequency range

2 Hz to 100 kHz

Frequency response

2 Hz to 50 kHz (–3 dB)

Dynamic range

108 dB or more

Total harmonic distortion rate

 

0.0012 % or less

Wow and flutter

Value of measurable limit (±0.001 %

 

W. PEAK) or less

When a CD is played

 

Frequency response

2 Hz to 20 kHz

Dynamic range

100 dB or more

Total harmonic distortion rate

 

0.0017 % or less

Wow and flutter

Value of measurable limit (±0.001 %

 

W. PEAK) or less

Output connector

 

 

Jack type

Output level

 

Load impedance

 

 

 

 

ANALOG OUT Phono

2 Vrms

 

Over 10 kilohms

 

jacks

(at 50 kilohms)

 

 

 

 

 

 

 

 

DIGITAL (CD)

Square

–18 dBm

(

Light emitting

)

OUT

optical

 

wave length:

OPTICAL*

output

 

660 nm

 

connector

 

 

 

 

 

 

 

 

 

 

DIGITAL (CD)

Coaxial

0.5 Vp-p

 

75 ohms

 

OUT

output

 

 

 

 

COAXIAL*

connector

 

 

 

 

 

 

 

 

 

 

PHONES

Stereo

10 mW

 

32 ohms

 

 

phone jack

 

 

 

 

 

 

 

 

*Output only the audio signals of the CD

 

 

 

General

 

 

 

 

 

Laser

 

Semiconductor laser

 

 

 

(SACD: λ = 650 nm)

 

 

 

(CD: λ = 780 nm)

 

 

 

 

Emission duration: continuous

 

Laser radiant power:

5.47 uW at 650 nm

 

*These output is the value measured at a distance of about 200mm from the objective lens surface on the optical pick-up.

Power requirements

230 V AC, 50/60 Hz

Power consumption

32 W

Dimensions (w/h/d)

430 × 130 × 380 mm

 

incl. projecting parts

Mass (approx.)

16 kg

Supplied accessories

See page 4.

Design and specifications are subject to change without notice.

28GB