GE Monogram 22, 20 About the automatic icemaker, Tips Installation, Icemaker Accessory Kit

Instructions

About the automatic icemaker.

A newly installed refrigerator may take 12 to 24 hours to begin making ice.

Instructions Operating Instructions Safety

Power		Automatic Icemaker (on some models)
Switch	Icemaker	The icemaker will produce seven cubes
		per cycle—approximately 100–130 cubes
		in a 24-hour period, depending on freezer
		compartment temperature, room
		temperature, number of door openings
		and other use conditions.
Green	Feeler Arm	See below for how to access ice and reach
Power Light		the power switch.
		If the refrigerator is operated before the
		water connection is made to the icemaker,
		set the power switch in the O (off) position.
		The icemaker power light will turn green
		when the freezer light switch is pressed in
		or when the freezer door is closed.
		When the refrigerator has been connected
		to the water supply, set the power switch to
		the l (on) position.
		The icemaker will fill with water when it
		cools to 15°F (–10°C). A newly installed
		refrigerator may take 12 to 24 hours to begin
		making ice cubes.

You will hear a buzzing sound each time the icemaker fills with water.

Throw away the first few batches of ice to allow the water line to clear.

Be sure nothing interferes with the sweep of the feeler arm.

When the bin fills to the level of the feeler arm, the icemaker will stop producing ice. It is normal for several cubes to be joined together.

If ice is not used frequently, old ice cubes will become cloudy, taste stale and shrink.

NOTE: In homes with lower-than-average water pressure, you may hear the icemaker cycle multiple times when making one batch of ice.

Tips Installation

Shelf

Ice Bin

To reach the power switch.

Accessing Ice and Reaching the Power Switch

To reach the icemaker power switch, pull the shelf above the ice bin straight out. Always be sure to replace the shelf.

To access ice, simply pull the bin forward.

Shelf

Ice Bin

To access ice.

Troubleshooting

Icemaker Accessory Kit

If your refrigerator did not come already	Check the back of the refrigerator for
equipped with an automatic icemaker,	the specific icemaker kit needed for
an icemaker accessory kit is available at	your model.
extra cost.

Consumer Support

To Use the Dispenser (on some models)

The water dispenser is located on the left wall inside the refrigerator compartment.

To dispense water:

Hold the glass against the recess.

Push the water dispenser button.

Hold the glass underneath the dispenser for 2–3 seconds after releasing the dispenser button.

12Water may continue to dispense after the button is released.

If no water is dispensed when the refrigerator is first installed, there may be air in the water line system. Press the dispenser button for at least 2 minutes to remove trapped air from the water line and to fill the water system. During this process, the dispenser noise may be loud as the air is purged from the water line system. To flush out impurities in the water line, throw away the first 6 glassfuls of water.

NOTE: To avoid water deposits, the dispenser should be cleaned periodically by wiping with a clean cloth or sponge.