Installation Instructions
5
REMOVE THE FRESH FOOD DOOR HANDLE
(For placement in the installation location or reversal of the handles – on some models)
Stainless steel (on some models):
AREMOVING
THE DOOR |
| Badge |
HANDLE: Loosen |
|
|
the set screws |
|
|
with the 3/32″ |
|
|
Allen wrench |
|
|
and remove | A | Plug |
the handle. |
| |
| Button | |
REVERSING THE |
|
|
DOOR HANDLE: | B |
|
•Remove the |
| |
handle mounting |
|
|
fasteners with a | Mounting |
|
1/4″ Allen |
| |
wrench and | Fasteners |
|
|
|
transfer the
handle mounting fasteners to the right side.
•Remove and transfer the plug button and logo badge to the left side of the fresh food door. NOTE: Use a flat plastic edge to prevent damaging the door. Remove any adhesive on the door with a mild detergent. Remove the paper covering on the adhesive backing on the logo badge prior to carefully attaching the badge to the door.
Plastic handle (on some models):
AREMOVING
THE DOOR |
| |
HANDLE: Slide | B | |
the handle up | ||
Badge | ||
on the handle | ||
mounting |
| |
fasteners and |
| |
remove the |
| |
handle. | A |
After removing the handle: Move the small plug button from the top right side of the door top and insert it into the hole on the opposite side.
Small
Plug
Button
(appearance may vary)
6REMOVE THE FREEZER DOOR HANDLE
Stainless steel handle:
ALoosen the set screws located on the underside of the handle with the 3/32″ Allen wrench and remove the handle.
NOTE: If the handle mounting fasteners need to be tightened or removed use a 1/4″ Allen wrench.
A
Plastic handle:
ASlide the handle to the right on the handle mounting fasteners and remove the handle.
NOTE: If the handle mounting fasteners need to be tightened or removed use a 3/8″ or 10 mm socket wrench.
REVERSING THE DOOR HANDLE:
•Remove the
handle mounting fasteners with a 3/8″ or 10 mm
socket wrench and transfer the handle mounting fasteners to the right side.
•Remove and transfer the plug button and |
logo badge to the left side of the fresh food |
door. NOTE: Use a flat plastic edge to prevent |
A
Mounting fasteners
A
A
damaging the door. Remove any adhesive on |
the door with a mild detergent. Remove the |
paper covering on the adhesive backing on |
the logo badge prior to carefully attaching the |
badge to the door. |
A |
| |
(appearance may vary) | Slots on back | |
of handle | ||
|
19
