Adjust the picture’s position manually (H Center /V Center)

If the picture is not in the center of the screen, adjust the picture’s centering as follows.

1Set the resolution to 1920 ⋅ 1200 on the computer.

2Load the Utility Disk.

3Start the Utility Disk and display the test pattern. For Windows

Click [Utility] t [Windows]/[Win Utility.exe].

For Macintosh

Click [Utility] t [Mac]/[Mac Utility].

4Press the MENU button.

The main menu appears on the screen.

5Press the M/m buttons to select (INPUT

SETTING) and press the OK button.

The INPUT SETTING menu appears on the screen.

6Press the M/m buttons to select “H Center” or “V

Center” and press the OK button.

The “H Center” adjustment menu or “V Center” adjustment menu appears on the screen.

7Press the M/m buttons to center the test pattern on the screen.

8Click [END] on the screen to turn off the test pattern.

xSelecting the Input Priority

When computers are connected to both of the monitor’s video input connectors (DVI-D and HD15) for either INPUT1 or INPUT2, you can choose the connector to which a signal is input preferentially.

For INPUT1, use “Input1 Priority,” and for INPUT2, use “Input2 Priority.”

INPUT SETTING

 

1: HD15

Auto Adjust :

On

 

Phase :

20

 

Pitch :

0

 

H Center :

50

 

V Center :

50

 

Input1 Priority :

DVI-D

 

Input2 Priority :

HD15

 

 

1920 ⋅

1200/60 Hz

Select

Set OK

Exit MENU

1Press the MENU button.

The main menu appears on the screen.

2Press the M/m buttons to select (INPUT

SETTING) and press the OK button.

The INPUT SETTING menu appears on the screen.

3Press the M/m buttons to select either “Input1

Priority” or “Input2 Priority” and press the OK button.

The options are displayed on the popup menu.

4Press the M/m buttons to select the desired mode.

•DVI-D (The default setting): The signal input to the DVI-D input connector (digital RGB) is displayed preferentially.

•HD15: The signal input to the HD15 input connector (analog RGB) is displayed preferentially.

If the monitor stays in the power saving mode and does not resume

Carry out the following procedures if the monitor stays in the power saving mode and does not resume when the computer being activated is connected to a video input connector for INPUT1 or INPUT2 other than the one selected in “Input1 Priority” or “Input2 Priority.”

1Press the 1 (power) switch.

An INFORMATION message (“No input signal”) appears on the screen.

2Press the MENU button while the INFORMATION message is being displayed.

If you use INPUT1, the “Input1 Priority” screen appears on the screen. (The “Input2 Priority” screen appears, if you use INPUT2.)

3Press the OK button and press the M/m buttons to select the input you want to display on the screen, then press the OK button again.

4Press the MENU button to return to normal viewing.

16