Symptom | Check these items |
Picture flickers, bounces, | • Adjust the pitch and phase (analog RGB signal only) (page 15). |
oscillates, or is scrambled. | • Isolate and eliminate any potential sources of electric or magnetic fields such as other |
| monitors, laser printers, electric fans, fluorescent lighting, or televisions. |
| • Move the monitor away from power lines or place a magnetic shield near the monitor. |
| • Try plugging the monitor into a different AC outlet, preferably on a different circuit. |
| • Change the orientation of the monitor. |
xProblem caused by a connected computer or other equipment, and not caused by the monitor
•Check your graphics board manual for the proper monitor setting.
•Confirm that the graphics mode (VESA, Macintosh 19'' Color, etc.) and the frequency of the input signal are supported by this monitor. Even if the frequency is within the proper range, some graphics boards may have a sync pulse that is too narrow for the monitor to sync with correctly.
•This monitor does not process interlace signals. Set for progressive signals.
•Adjust the computer’s refresh rate (vertical frequency) to obtain the best possible picture (60 Hz is recommended).
Picture is fuzzy. | • | Adjust the brightness and contrast (page 13). |
| • | Adjust the pitch and phase (analog RGB signal only) (page 15). |
xProblem caused by a connected computer or other equipment, and not
caused by the monitor
• Set the resolution to 1920 ⋅ 1200 on your computer.
Picture is ghosting. | • | Eliminate the use of video cable extensions and/or video switch boxes. |
| • | Check that all plugs are firmly seated in their sockets. |
Picture is not centered or sized properly (analog RGB signal only).
Picture is too small. | • | Set the zoom setting to “Full2” (page 17). | |
|
| x Problem caused by a connected computer or other equipment, and not | |
|
|
| caused by the monitor |
|
| • | Set the resolution to 1920 ⋅ 1200 on your computer. |
|
|
| |
Picture is dark. | • | Adjust the brightness (page 13). | |
|
| • Adjust the backlight (page 13). | |
|
| • It takes a few minutes for the display to become bright after turning on the monitor. | |
|
| • | Adjust the gamma using “Gamma” on the PICTURE ADJUSTMENT menu (page 14). |
|
| • If you press the ECO button, the screen turns darker. | |
|
|
| |
Wavy or elliptical pattern (moire) | • | Adjust the pitch and phase (analog RGB signal only) (page 15). | |
is visible. |
|
| |
|
|
| |
Color is not uniform. | • | Adjust the pitch and phase (analog RGB signal only) (page 15). | |
|
|
| |
White does not look white. | • | Adjust the color temperature (page 13). | |
|
|
| |
Monitor buttons do not operate | • | If “Menu Lock” on the OPTION menu is set to “On,” set it to “Off” (page 17). | |
( | appears on the screen). |
|
|
|
|
| |
Resolution displayed on the menu | • | Depending on the graphics board setting, the resolution displayed on the menu screen may | |
screen is incorrect. |
| not coincide with the one set on the computer. | |
|
|
| |
After turnig off the main power, | • | When the main power is on but the 1 (power) switch is not pressed, or when the monitor | |
the 1 (power) indicator stays |
| is in the power saving mode, if you turn the MAIN POWER switch off, the 1 (power) | |
bright for a while. |
| indicator may not turn off right away. This is not a malfunction. | |
|
|
| |
|
|
|
|
21