Front door opened

1 2

3

9

8 7 6 5

4

APower Switch

Press this switch to turn the S-AIT Tape Drive Unit on or off. When you restart the unit, be sure to wait at least 10 seconds before turning it on again.

BPOWER Indicator

Lights green when the unit is on. When it flashes, the cooling fan of the unit may be malfunctioning. If this is the case, verify that the cooling fan on the rear is operating normally. If it is not, contact your dealer.

CCartridge SlotUsed to insert and remove cartridges.DEject Button

Push to manually eject cartridges from the unit. The unit ejects cleaning cartridges automatically.

ECLEANING REQUEST Indicator

Flashes yellow when the read/write heads need cleaning. For details about cleaning, see “Head Cleaning” on page 41.

FTAPE ERROR Indicator

Flashes or lights orange when media errors occur. When media warnings occur, the indicator flashes yellow. In this case, copy data to another cartridge.

GDRIVE ERROR IndicatorFlashes orange or yellow when drive errors occur.HTAPE MOTION Indicator

Lights when you insert cartridges. The color of the indicator, shows whether the cartridge is write-protected. Moreover, when the unit is operating, the indicator flashes. The color of the flashing indicator shows the status of the unit.

IHardware Reset Hole

Used to reset the unit in case of emergency. Using the emergency reset hole when reading or writing data may damage your data, therefore this procedure should only be used for maintenance purposes.

Chapter 1 Introduction

11