The SDZ-S130 (Fibre Channel interface model) and the host computer cannot communicate with each other

•Verify that the host computer is on.

•Verify the FC status indicator at the rear of the unit. If it is lit orange, there is a connection error. In this case, reconnect the cable or change it if necessary.

•Verify that an optical fiber cable is correctly connected from the unit to the host computer, hub, or switch.

•Verify that the optical fiber cable is of the appropriate type. For details, see “Connecting the Optical Fiber Cable for Fibre Channel (SDZ-S130 only)” on page 29.

•Verify that the Loop ID is set correctly. For details, see “Setting the Loop ID (SDZ-S130 only)” on page 23.

Your software does not detect the unit

•Verify that your software supports the S-AIT Tape Drive Unit. For details about software that can be used on the S-AIT Tape Drive Unit and supported operating systems, contact your dealer.

•Verify that the software is correctly installed and set up on the host computer.

•If the software requires a device driver, install the appropriate device driver. For details, contact your dealer.

Media error detected

Push the eject button. If the cartridge is ejected, reset the unit and try to insert a new one.

Drive error detected

Push the eject button. If the cartridge is ejected, reset the unit and try to insert a new one.

46 Appendix