Connecting the Power Cable

1 Verify the power cable plug to make sure that it matches the AC IN connector receptacle.

2 Make sure that the electrical outlet you use to connect the unit is properly grounded.

3 Connect one end of the power cable to the AC IN connector and the other end to the power outlet.

Note

If the S-AIT drive does not come with a power cable, make sure that you connect a power cable appropriate for your country to this connector.

AC Power

Installing Device Drivers

A device driver is host firmware that allows the S-AIT Tape Drive Unit to interact with a variety of hosts.

If your software requires it, install the appropriate device driver for your system.

For details, contact your dealer.

The latest device drivers and documentation for the S-AIT Tape Drive Units are available online. Contact your dealer for details or visit the Sony Web site (http://www.sony.net/Products/storagesolution/).

If you are using a SDZ-S100 (SCSI model), proceed to “Connecting the SCSI Bus Cable (SDZ-S100 only)” on page 27.

If you are using a SDZ-S130 (Fibre Channel interface model), proceed to “Connecting the Optical Fiber Cable for Fibre Channel (SDZ-S130 only)” on page 29.

26 Chapter 2 Installation