Sony SLV-E580EG manual Manual setup Setting up ShowView

Manual setup — Setting up ShowView (continued)

5 Select CHANNEL SET, then press CURSOR ?//repeatedly to tune the VCR to the satellite tuner.

The channel number displayed beside CHANNEL SET is used for receiving all satellite broadcasts from the satellite tuner.

Remember this number for the following steps.

TUNER	PROG 6
SYSTEM	[ D / K	]
NORMAL / CATV	[ NORM]
CHANNEL SET	[ C3 0	]
PAY-TV/CANAL+	[ OFF	]
AFT	[ ON	]

FINE TUNING
SELECT	:
SET	:

6 Press PROG +/– to select another programme position for the next satellite channel, and press the programme number buttons to enter the same channel number as the one displayed in step 5. Otherwise, the setting will not be memorized.

Repeat this step for all satellite channels, then press OK.

7 Set the guide channel number for each programme position assigned to the satellite channel, following the procedures on page 24.

Notes

•The menu disappears automatically if you don’t proceed for more than a few minutes.

•If you use a satellite tuner connected via the LINE-1 IN (TV) connector, you don‘t have to set up ShowView. Just record a satellite programme using ShowView, and the VCR automatically records the programme from the LINE-1 IN (TV) connector.

•If you inadvertently entered a guide channel number, press CLEAR.

•The VCR does not allow entering the guide channel number if the same number has been set.

•When you record a satellite broadcast using ShowView, you need to select the desired channel on the satellite tuner manually.

26

Getting Started