Tip

• To set tracking to the centre position, press the TRACKING + and – buttons at the same time.

Notes

You can adjust the tracking for an NTSC*1-recorded tape but the tracking meter won’t be displayed.

With the Auto Long Play function on, the OPC function will work only in SP mode. If the tape speed automatically switches from SP to LP, the OPC function turns off. If, however, the entire programme is recorded in LP mode, the OPC function will work.*2

There is a delay of about ten seconds before the VCR actually starts recording while the VCR analyses the tape. To avoid the delay, first set the VCR to recording pause (the OPC indicator flashes slowly) and press z REC to have the VCR analyse the tape (the OPC indicator flashes rapidly) and return to recording pause. After the OPC indicator stops flashing, press X PAUSE to start recording immediately.

If you want to start recording quickly without using the OPC function, first set the VCR to recording pause (the OPC indicator flashes slowly) and press X PAUSE again to start recording.

*1 SLV-SE100A1/A2 cannot play NTSC-recorded tapes. *2 not available on SLV-SE100A1/A2 and SE200V1/V2

Operations Additional

Adjusting the picture 73