time is adjusted using the time zone difference and set on the camera.

•Due to the network properties, there may be a slight difference between the actual time and the time set on the camera.

Date time format

Select the format of date and time to be displayed on the monitor image from the drop-down list.

You can select from among yyyy-mm-dd hh:mm:ss (year-month-day hour:minute:second), mm-dd-yyyy hh:mm:ss (month-day-year hour:minute:second), and dd-mm-yyyy hh:mm:ss (day-month-year hour:minute:second).

Click Apply to transfer the setting to the camera.

Synchronization with NTP server

Synchronizes the camera's time with that of the NTP (Network Time Protocol) server.

Select On to activate the time synchronization, and Off to deactivate it.

NTP server name

Type the host name or IP address of the NTP server, up to 64 characters.

This setting is valid when the Synchronization with NTP server menu is set to On.

Interval time

Select the interval at which you want to adjust the camera's time referring to the NTP server' time, between 1 and 24 hours. The set interval is a guide, and does not indicate the exact time.

This setting is valid when the Synchronization with NTP server menu is set to On.

Note

The time adjusted by this function may be slightly in error depending on the network environments between the camera and the NTP server.

Initialization SectionBackup setting

Saves the setting data of the camera in a file.

Click Save, and follow the instructions on the browser to specify the folder and save the setting data of the camera. The file name preset at the factory is “snc- cs3.cfg.”

Restore setting

Loads the stored setting data of the camera.

Click Browse and select the file in which the setting data is stored. Then, click Apply, and the camera is adjusted according to the loaded data and restarted.

Note

The IP address setting in the Wired LAN setting section (see page 22) on the Network setting page cannot be set.

Reboot

Reboots the camera.

Click Reboot, and “The SNC-CS3 will be rebooted. Are you sure?” appears. Click OK to reboot the camera.

Factory default

Resets the camera to the factory settings. Click Factory default, and “All configuration information will be initialized as factory setting. Are you sure?” appears. Click OK to reset to the factory settings.

Camera the Administrating

Configuring the System — System setting Page

19