Other Operations

Changing the display

Note

When “STEREO” appears in the display, the current program is broadcasted in the stereo/joint (intensity) stereo mode.

You can check the status of this tuner and the information about the programme using the display.

Be sure to use the buttons on the tuner for this operation.

Press DISPLAY.

Each time you press the button, the display changes cyclically as follows.

FM and AM band

Program Service namea) or index name of the preset stationb) t Frequency t Program Type indicationa) t Radio Text indicationa)

tCurrent Time indication (in 24-hour system)a)

a)During RDS reception only (page 23).

b)Index name appears only when you have assigned one to the preset station (page 23). Index name does not appear when only blank spaces have been entered.

DAB band

Service Component Label t Frequency t Program Type indication t Dynamic label segment t Current Time indication (in 24- hour system)a) t Channel label t Audio infob) t Signal Qualityc)

a)Time information appearing in the display is sent by the DAB station. As a result, the time may not be displayed properly if the station is located in a different time zone.

“_ _H _ _M” will display until time information is received.

b)Audio information on bit rate (32kbps - 256kbps), signal type (stereo, dual, mono) and sampling type (F: 48kHz, H: 24kHz) is displayed.

Example: 128K S F

c)The DAB station signal quality is displayed. “Q. _ _ _” is displayed until the signal quality information is received.

Operations Other

25GB