The appropriate display or information does not appear.

•Contact the radio station and find out whether or not they actually provide the service in question. The service may be temporarily out of order.

You cannot name the preset station.

• You cannot name DAB/FM RDS stations.

The tuner malfunctions.

•The microprocessor in the tuner has malfunctioned. Turn off the tuner, then turn it on again.

“DAB _ _ _ _” appears in the display. (DAB reception only)

•Check all antenna connections, then turn TUNING/SELECT to select a service.

•The current DAB service is not available. Turn TUNING/SELECT to select a different service.

•If you have moved to another area, some services/frequencies may have changed and you may not be able to tune into your usual broadcast.

Perform the DAB INITIAL SCAN procedure to re-register the contents of broadcasts. (Performing this procedure clears all previously stored presets.)

There’s no sound from the DIGITAL DAB OPTICAL OUT jack, or you cannot record a programme.

•Make sure that the optical digital cord is properly connected.

•The connected recorder does not support the 48kHz sampling frequency mode. Use a recorder that supports this mode.

•The sound of the FM and AM programme does not output from the DIGITAL DAB OPTICAL OUT jack of the tuner. Connect the recorder to the ANALOG OUT jack of the tuner.

The FM reception is poor.

•Use a 75-ohm coaxial cable (not supplied) to connect the tuner to an outdoor FM antenna as shown below. If you connect the tuner to an outdoor antenna, ground it against lightning. To prevent a gas explosion, do not connect the ground wire to a gas pipe.

Outdoor FM antenna

Tuner

ANTENNA

AM

Ground wire (not supplied)

To ground

Remote control

The remote does not function.

•Point the remote at the remote sensor () on the tuner.

•Remove any obstacles in the path between the remote and the tuner.

•Replace both batteries in the remote with new ones if they are weak (page 14).

Error messages

If there is a malfunction, the display shows a message. You can check the condition of the tuner by the message. Refer to the following table to solve the problem.

DAB EROR

The tuner is unable to collect the DAB data. Turn off the tuner and turn it on again.

28GB