Advanced settings (continued)
xSURROUND HGT. (SLSR) (Surround speaker height)*
Lets you specify the hight of your surround speakers for proper implementation of the surround effects of the Cinema Studio EX modes (page 34).
B | B |
| 60 |
A | A |
| 30 |
•LOW
Select if the height of your surround speakers corresponds to section A.
•HIGH
Select if the height of your surround speakers corresponds to section B.
*This setup item is not available when “SURROUND” (surround speaker size) is set to “NO”.
xFRT > XXX Hz
(Front speaker crossover frequency)
Initial setting: STD (120 Hz)
Lets you adjust the front speaker bass crossover frequency when “FRONT” (front speaker size) is set to “SMALL”. You can adjust from 40 Hz to 200 Hz in 10 Hz steps.
xCTR > XXX Hz
(Center speaker crossover frequency)
Initial setting: STD (120 Hz)
Lets you adjust the center speaker bass crossover frequency when “CENTER” (center speaker size) is set to “SMALL”. You can adjust from 40 Hz to 200 Hz in 10 Hz steps.
xSUR. > XXX Hz
(Surround speaker crossover frequency)
Initial setting: STD (120 Hz)
Lets you adjust the surround speaker bass crossover frequency when “SURROUND” (surround speaker size) is set to “SMALL”. You can adjust from 40 Hz to 200 Hz in 10 Hz steps.
xL.F.E. > XXX Hz (LFE high cut filter)
Initial setting: STD (120 Hz)
Lets you select the cut off frequency of the LFE channel high cut filter. Normally, select “STD (120 Hz)”.
When using a passive sub woofer powered by a separate power amplifier, it may be better to change the cut off frequency. In this case, you can adjust from 40 Hz to 200 Hz in 10 Hz steps.
Advanced SURROUND menu parameters
When “MENU” is set to “MENU EXP.”, all of the following parameters are displayed and adjustable.
See page 37 for the SURROUND menu adjustments.
Initial settings are underlined.
All SURROUND menu parameters
C.WIDTH X*
DIMEN. X*
PANO.*
EFFECT XX
WALL XXX*
REVB. XXX*
SCR.*
*Adjustable only when “MENU” is set to “MENU EXP.”.
xC WIDTH X
(Center width control)
Initial setting: 3
Lets you perform further adjustments for Dolby Pro Logic II Music mode decoding (PLII MUSIC). You can set this parameter only when “2CH MODE” is set to “PLII MUSIC” (page 36) and NORMAL SURROUND is selected.
You can adjust the distribution of the center channel signal, generated through the Dolby Pro Logic II decoding, to the L/R speakers. C WIDTH is adjustable in 8 steps from “0” (no spread) to “7” (full phantom).