the receiver and the remote is different, you cannot operate the receiver with the remote. For the command mode of the remote, refer to the operating instructions supplied with the remote. To switch the command mode of the receiver, press ?/1 while pressing INPUT MODE. Each time you press ?/1, the command mode switches between “C.MODE [AV2]” and “C.MODE [AV1]”. (The initial setting is “C.MODE [AV2]”.)
•Make sure you select the correct input on the remote.
*Models of area code CEL only.
Error messagesIf there is a malfunction, the display shows a code of two numbers and a message. You can check the condition of the system by the message. Refer to the following table to solve the problem. If any problem persists, consult your nearest Sony dealer.
DECODE ERROR/CHECK CODE 01Appears when the signal which the receiver cannot decode (ex.
Irregular current output to the speakers. Turn off the receiver and check the speaker connection. Then turn on the power again.
PROTECTOR/CHECK CODE 12
The amplifier section is overheated. Turn off the receiver and check that the ventilation hole is not covered. Leave the receiver for a while and turn on the power again.
PROTECTOR/CHECK CODE 13
The power supply section is overheated. Turn off the receiver and check that the ventilation hole is not covered. Leave the receiver for a while and turn on the power again.
PROTECTOR/CHECK CODE 21
Turn off the receiver and consult your nearest Sony dealer.
PROTECTOR/CHECK CODE 22
There is a problem with the power circuit. Turn off the receiver and check the speaker connection. Then turn on the power again.