You can also use the FM/AM button on the receiver.
3 Select “DIRECT TUNING” from the SUB menu.
4 Select the numbers for the frequency using the NUM menu.
Example 1: FM 102.50 MHz
Select “FM/AM” from the SUB menu to select the FM or AM band.
2
Select “TUNER” from the FUNCTION list to switch the function to TUNER. You can also use the FUNCTION control on the receiver.
1
Models of other area codes Use the supplied remote RM-LP211.

Listening to FM/AM radio (continued)

Direct tuning

Enter a frequency of the station directly by using the numeric buttons or NUM menu on the remote.

For details on the supplied remote, refer to the operating instructions supplied with the remote.

Models of area code U, CA

Use the supplied remote RM-PG411.

1 Press TUNER to switch the function to

TUNER.

You can also use the FUNCTION control on the receiver.

2 Press FM/AM button on the receiver repeatedly to select FM or AM band.

3 Press D.TUNING.

4 Select the numbers for the frequency.

Example 1: FM 102.50 MHz

1 b 0 b 2 b 5 b 0

Example 2: AM 1,350 kHz

(You don’t have to enter the last “0” when the tuning scale is set to 10 kHz.)

1 b 3 b 5 b 0

Press 1 b 0 b 2 b 5 b 0

Example 2: AM 1,350 kHz

(You don’t have to enter the last “0” when the tuning scale is set to 10 kHz.)

Press 1 b 3 b 5 b 0

If you’ve tuned in an AM station, adjust the direction of the AM loop antenna for optimum reception.

If you cannot tune in a station and the entered numbers flash

Make sure you’ve entered the right frequency. If not, repeat steps 3 and 4. If the entered numbers still flash, the frequency is not used in your area.

26GB