4:Connecting the AC power cord
Setting the voltage selectorIf your receiver has a voltage selector on the rear panel, check that the voltage selector is set to the local power supply voltage. If not, use a screwdriver to set the selector to the correct position before connecting the AC power cord to a wall outlet.
120V 240V 220V
VOLTAGE SELECTORConnecting the AC power cordConnect the AC power cord to a wall outlet.
NT A |
|
|
| L |
|
– | + | b |
| L | |
NT B |
| To a wall |
| outlet | |
|
|
– +
CENTER
AC OUTLET
AC OUTLET* AC power cord
*The configuration, shape and number of AC outlets vary according to the area code.
Notes
•The AC OUTLET(s) on the rear of the receiver is a switched outlet, which supplies power to the connected component only while the receiver is turned on.
•Make sure that the total power consumption of the component(s) connected to the receiver’s AC OUTLET(s) does not exceed the wattage stated on the rear panel. Do not connect
Before using the receiver for the first time, initialize the receiver by performing the following procedure.
This procedure can also be used to return settings you have made to their factory defaults. Use the buttons on the receiver for the operation.
1 Press ?/1 to turn off the receiver.2 Hold down ?/1 for 5 seconds.“PUSH ENTER” flashes in the display.
3 Press ENTER.“MEMORY CLEARING” appears in the display for a while, then “MEMORY CLEARED” appears.
The following are reset to their factory settings.
•All settings in the SET UP, LEVEL, EQUALIZER and CUSTOMIZE menus.
•The sound field memorized for each input and preset station.
•All sound field parameters.
•All preset stations.
•All index names for inputs and preset stations.
•MASTER VOLUME
•Input is set to DVD.
Started Getting