FM or AM band.
The last received station is tuned in.
Tip
You can also use INPUT SELECTOR on the receiver.
2 Press D.TUNING.
3 Press the numeric buttons to enter the frequency.
Example 1: FM 102.50 MHz Press 1 b 0 b 2 b 5 b 0 Example 2: AM 1,350 kHz
(You do not have to enter the last “0” when the tuning scale is set to 10 kHz.)
Press 1 b 3 b 5 b 0
If you have tuned in an AM station, adjust the direction of the AM loop antenna for optimum reception.
If you cannot tune in a station and the entered numbers flash
Make sure you have entered the right frequency. If not, repeat steps 2 and 3. If the entered numbers still flash, the frequency is not used in your area.
Press TUNER repeatedly to select the
1
Direct tuning
You can enter the frequency of the station you want directly. Use the remote for the operation.

Presetting radio stations

You can preset up to 30 FM or AM stations. Then you can easily tune in the stations you often listen to.

Presetting radio stations

1 Turn INPUT SELECTOR to select the FM or AM band.

The last received station is tuned in.

2 Tune in the station that you want to preset using Automatic Tuning (page 23) or Direct Tuning (page 24).

3 Press MEMORY.

“MEMORY” appears in the display for a few seconds. Do steps 4 to 5 before the display goes out.

4 Press PRESET TUNING + or PRESET TUNING – repeatedly to select a preset station number.

Each time you press the button, you can select the preset station number as follows:

tA1yA2y...yA0yB1yB2y...yB0T

tC0y...yC2yC1T

If “MEMORY” goes out before you select the preset station number, start again from step 3.

Tip

You can also use the remote to select a preset station number. Press SHIFT repeatedly to select a memory page (A, B or C) and then press the numeric button to select a preset number.

5 Press MEMORY again.

The station is stored to the selected preset number.

If “MEMORY” goes out before you press MEMORY, start again from step 3.

6 Repeat steps 2 to 5 to preset another station.
24GB