Tip

If programming is unsuccessful, check the following:

If the indicator does not light up in step 1, the batteries are weak. Replace both batteries.

If the indicator lights up 4 times in quick succession in step 3, an error has occurred. Start again from step 1.

To cancel programming

Press RM SET UP during any step. The remote automatically exits the macro setting mode.

To delay the output of an IR code

Start over from step 1. In step 3,

Press M1 (TV/SAT) when the macro setting is M1.

Press M2 (TAPE) when the macro setting is M2.

1 second delay is programmed at this program step. The indicator lights up twice slowly, then the remote automatically exits the macro setting mode.

To clear the programmed IR codes

Clear each macro step individually. In step 3,

Press M1 (TV/SAT) when the macro setting is M1.

Press M2 (TAPE) when the macro setting is M2.

The IR code is cleared. The indicator lights up twice slowly, then the remote automatically exits the macro setting mode.

To start macro playPress M1 (TV/SAT) or M2 (TAPE) while the ALT indicator turns on.

Note

If the Macro Play function does not work properly, program a delay between each operation. See “To delay the output of an IR code”.

PG413-RM Remote the Using Operations

53GB