Remote

Operations

Function

Button

 

 

 

 

 

H qs

VCR/

Starts playback.

 

CD player/

 

 

VCD player/

 

 

LD player/

 

 

DVD player/

 

 

MD deck/

 

 

DAT deck/

 

 

Tape deck

 

 

 

 

X qd

VCR/

Pauses playback or

 

CD player/

record. (Also start

 

VCD player/

recording with

 

LD player/

components in record

 

DVD player/

standby.)

 

MD deck/

 

 

DAT deck/

 

 

Tape deck

 

 

 

 

x ea

VCR/

Stops playback.

 

CD player/

 

 

VCD player/

 

 

LD player/

 

 

DVD player/

 

 

MD deck/

 

 

DAT deck/

 

 

Tape deck

 

 

 

 

O qf

VCD player/

Returns to the previous

 

LD player/

menu or exits the menu.

 

DVD player

 

 

 

 

V/v/B/b

VCR/

Selects a menu item.

qf

Satellite tuner/

 

 

DVD player

 

 

 

 

-/-- e;

TV

Selects the channel

 

 

entry mode, either one

 

 

or two digit.

 

 

 

2ND ql

Remote

Selects the command

 

 

mode of the remote.

 

 

 

Notes

Some functions explained in this section may not work depending on the model.

The above explanation is intended to serve as an example only. Therefore, depending on the component the above operation may not be possible or may operate differently than described.

To activate the buttons with orange printing, press ALT first before pressing the buttons.

When you press input buttons (VIDEO1, VIDEO2, VIDEO3 or DVD), the input mode of the TV might not switch to the corresponding input mode that you want. In this case, press TV/VIDEO button to switch the input mode of the TV.

The 2ND button on the remote is not available for receiver operation.

Selecting the command mode of the remote

Set the remote command mode using the RM SET UP button and the remote command mode buttons.

Selecting the command mode

You can switch the command mode (AV1 and AV2) of the remote. If the command mode of the receiver and the remote is different, you cannot use the remote to operate the receiver.

Press AV1 or AV2 while holding down RM SET UP.

The indicator flashes once (twice for AV2) , then the command mode switches.

To check the command mode of the remote

Press RM SET UP. You can check the remote by the indicator.

Mode

Indicator flashes

AV1once

AV2twice

To reset the remote to factory settingsPress ?/1, AV ?/1 and MASTER VOL – at the same time.

The indicator flashes 3 times, then goes off.

Note

If the command mode of the receiver and the remote is different, you cannot use the remote to operate the receiver. To change the command mode of the receiver, see page 57.

PG413-RM Remote the Using Operations

47GB