Remote | Operations | Function |
Button |
|
|
|
|
|
x qd | VCR/ | Stops playback. |
| CD player/ |
|
| VCD player/ |
|
| LD player/ |
|
| DVD player/ |
|
| MD deck/ |
|
| DAT deck/ |
|
| Tape deck/ |
|
|
| |
| recorder/ |
|
| Hard disc |
|
| recorder/PSX |
|
|
|
|
O ws | VCD player/ | Returns to the previous |
| LD player/ | menu or exits the menu. |
| DVD player/ |
|
| Satellite tuner/ |
|
|
| |
| recorder/ |
|
| Hard disc |
|
| recorder/PSX |
|
|
|
|
V/v ws | Receiver | Selects a menu item. |
|
|
|
B/b ws | Receiver | Adjusts or changes the |
|
| setting. |
|
|
|
V/v/B/b | VCR/ | Selects a menu item. |
ws | Satellite tuner/ |
|
| DVD player |
|
|
|
|
TV/ | Selects the channel | |
| Satellite tuner/ | entry mode, either one |
| or two digit. | |
| recorder/ |
|
| Hard disc |
|
| recorder/PSX |
|
|
|
|
2ND 3 | Remote | Selects the command |
|
| mode of the remote. |
|
|
|
Notes
•Some functions explained in this section may not work depending on the model.
•The above explanation is intended to serve as an example only. Therefore, depending on the component the above operation may not be possible or may operate differently than described.
•To activate the buttons with orange printing, press ALT first before pressing the buttons.
•When you press input buttons (VIDEO1, VIDEO2, VIDEO3, TV/SAT or DVD), the input mode of the TV might not switch to the corresponding input mode that you want. In this case, press TV/VIDEO button to switch the input mode of the TV.
Selecting the command mode of the remote
Set the remote command mode using the RM SET UP button and the remote command mode buttons.
Selecting the command modeYou can switch the command mode (AV1 and AV2) of the remote. If the command mode of the receiver and the remote is different, you cannot use the remote to operate the receiver.
Press AV1 or AV2 while holding down RM SET UP.The indicator flashes once (twice for AV2) , then the command mode switches.
To check the command mode of the remotePress RM SET UP. You can check the remote by the indicator.
Mode | Indicator flashes |
AV1once
AV2twice
To reset the remote to factory settingsPress ?/1, AV ?/1 and MASTER VOL – at the same time.The indicator flashes 3 times, then goes off.
Note
If the command mode of the receiver and the remote is different, you cannot use the remote to operate the receiver. To change the command mode of the receiver, see page 59.