There is no sound or only a very
•Select a CINEMA STUDIO EX mode (page 31).
•Adjust the speaker level (page 22).
•Make sure the center/surround speakers size parameter are set to either “SMALL” or “LARGE” (pages 19).
•Make sure the surround back speakers selection is set to either “DUAL” or “SINGLE”.
There is no sound from the sub woofer.•Check that the sub woofer is connected correctly and securely.
•Make sure the sub woofer selection parameter is set to “YES” (page 18).
•There is no sound output from the sub woofer depending on the sound field.
The surround effect cannot be obtained.•Make sure the sound field function is on (press MOVIE or MUSIC).
•Sound fields do not function for the signals with a sampling frequency of more than 48 kHz.
Dolby Digital or DTS multi channel sound is not reproduced.•Check that the playing DVD, etc. is recorded in Dolby Digital or DTS format.
•When connecting the DVD player, etc. to the digital input jacks of this receiver, check the audio setting (settings for the audio output) of the connected component.
Recording cannot be done.•Check that the components are connected correctly.
•Select the source component with INPUT SELECTOR.
•Make sure that INPUT MODE is set to “ANALOG FIXED” (page 36) before recording from a digital component connected to the analog MD/TAPE jacks.
•Make sure that INPUT MODE is set to “COAX FIXED” or “OPT FIXED” (page 36) before recording from a digital component connected to the DIGITAL OPTICAL MD/TAPE OUT jack.
•Use a
Outdoor FM antenna
Receiver
ANTENNA
AM
Ground wire (not supplied)
To ground
Radio stations cannot be tuned in.•Check that the antennas are connected securely. Adjust the antennas and connect an external antenna if necessary.
•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.
•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).
•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 25).
•Press DISPLAY repeatedly so that the frequency appears in the display.
There is no picture or an unclear picture appears on the TV screen or monitor.•Select the appropriate input on the receiver.
•Set your TV to the appropriate input mode.
•Move your TV away from the audio components.
The DIGITAL OPTICAL MD/TAPE OUT jack flashes red.•When “AUTO 2CH” is selected for INPUT MODE, the jack flashes red when no digital audio signal is input. This depends on the INPUT MODE function, and is not a malfunction.