Sony STR-DG710 Performing Auto Calibration, Tip, Note, 28GB, level, Display, NOISE.CHK, alternately, MEASURE and, alternately, DET. appears, Speaker level, MEASURE and SP

Performing Auto Calibration

TV INPUT	DMPORT	TV ?/1	?/1	?/1
SLEEP		AV ?/1
				switch
		SYSTEM STANDBY
VIDEO 1	VIDEO 2	VIDEO 3	DVD
				Input
SAT	TV	SA-CD/CD	TUNER	buttons
2CH	A.F.D.	MOVIE	MUSIC
		AMP MENU		1
1	2	3
4	5	6	AUTO CAL	2
7	8	9	D.TUNING
			D.SKIP
>10/		MEMORY	DVD MENU
-	0/10	ENTER
CLEAR			FM MODE
DISPLAY		TOOLS	MUTING	MUTING
	F
			TV VOL
		MASTER VOL
G		g		MASTER
	f			VOL +/–
RETURN/EXIT		MENU

1 Press AMP MENU.2 Press AUTO CAL.Measurement starts in 5 seconds and the display changes as follows:A.CAL [5] t A.CAL [4] t A.CAL [3]tA.CAL [2] t A.CAL [1]

While the time is counting down, stand away from the measurement area to avoid measurement error.

3 Measurement starts.The measurement process will take a few minutes to complete.The table below shows the display when measurement starts.

Measurement for	Display
Environment noise	NOISE.CHK
level
Speaker connection	MEASURE and SP
	DET. appears
	alternately*
Speaker level	MEASURE and GAIN
	appears alternately*
Speaker distance	MEASURE and
	DISTANCE appears
	alternately*

*The corresponding speaker indicator lights up in the display during measurement.

4 Measurement ends.“COMPLETE” appears on the display and the settings are registered.5 Disconnect the optimizer microphone from the AUTO CAL MIC jack.

Note

Auto Calibration cannot detect the sub woofer. Therefore, all sub woofer settings will be maintained.

Tip

During the measurement process, Auto Calibration is canceled when you do the following.

–Press ?/1, input buttons or MUTING.–Change the volume level.–Press AUTO CAL again.

28GB