Sony STR-DN1050, STR-DN850 Checking Auto Calibration results, If an error code appears, If a warning message appears

MULTI CHANNEL AV RECEIVER

STR-DN1050/STR-DN850

Checking Auto Calibration results

To check error codes or warning messages received in [Auto Calibration], proceed with the following steps:

If an error code appears

Check the error and perform Auto Calibration again.

1. Select [Retry].

2. Follow the instructions on the TV screen and then press to select [Start].

The measurement starts in five seconds.

The measurement process will take approximately 30 seconds with a test tone.

When the measurement ends, a beep sounds and the screen switches.

3. Select the item you want.

Save: Saves the measurement results and exits the setting process.

Retry: Performs the Auto Calibration again.

Discard: Exits the setting process without saving the measurement results.

4. Save the measurement results.

Select [Save] in step 3.

If a warning message appears

Check the warning message and select [OK ]. For details on the warning messages, see “List of messages after Auto

Calibration measurements.”

Hint

The measurement results may vary depending on the position of the subwoofer. However, continuing to use the

receiver with that value does not cause problems.