Sony STR-DN2010 Clearing all the contents of the remotes memory 1, 2, Precautions

135GB
D:\NORM'S JOB\SONY HA\SO0071\STR-DN2010\GB\GB07ADD_STR-DN2010-CEL.fm masterpage: Right
STR-DN2010
4-182-049-11(1)
Additional Information
Clearing all the contents
of the remote’s memory
1While holding down MASTER
VOL – (RM-AAP055 only) or
2 – (RM-AAP056 only), press
and hold ?/1, then press
AV ?/1.
The RM SET UP indicator flashes 3
times.
2Release all buttons.
All the contents of the remote’s memory
(i.e., all the programmed data) are
cleared.
Precautions
On safety
Should any solid object or liquid fall into the
cabinet, unplug the receiver and have it
checked by qualified personnel before
operating it any further.
On power sources
• Before operating the receiver, check that the
operating voltage is identical with your local
power supply.
The operating voltage is indicated on the
nameplate on the back of the receiver.
• The unit is not disconnected from the AC
power source (mains) as long as it is
connected to the wall outlet, even if the unit
itself has been turned off.
• If you are not going to use the receiver for a
long time, be sure to disconnect the receiver
from the wall outlet. To disconnect the AC
power cord (mains lead), grasp the plug
itself; never pull the cord.
• (USA model only)
One blade of the plug is wider than the other
for the purpose of safety and will fit into the
wall outlet only one way. If you are unable to
insert the plug fully into the outlet, contact
your dealer.
• The AC power cord (mains lead) must be
changed only at a qualified service shop.
On heat buildup
Although the receiver heats up during
operation, this is not a malfunction. If you
continuously use this receiver at a large
volume, the cabinet temperature of the top,
side and bottom rises considerably. To avoid
burning yourself, do not touch the cabinet.
Additional Information
continued