Sony STR-DN2010 Function for conversion of video signals, Notes on converting video signals, To connect a recording component

33GB
D:\NORM'S JOB\SONY HA\SO0071\STR-DN2010\GB\GB04GET_STR-DN2010-CEL.fm masterpage: Right
STR-DN2010
4-182-049-11(1)
Connections
Function for conversion of video signals
The receiver is equipped with a function for converting video signals.
• Composite video signals can be output as HDMI video and component video signals
• Component video signals can be output as HDMI video and video signals.
a: Video signals are output.
– : Video signals are not output.
* HDMI video signals cannot be converted to component video signals and video signals.
As the initial setting, video signals input from the connected component are output as shown in the
table above. We recommend that you set the video conversion function to match the resolution of
the monitor you are using. For details, see “Video Settings menu” (page 116).
Notes on converting video
signals
• When video signals from a VCR, etc., are
converted on this receiver and then output to
your TV, depending on the status of the
video signal output, the image on the TV
screen may appear distorted horizontally or
no image may be output.
• The converted video signals are not output
from the VIDEO OUT jack.
• When you play back a VCR with an image
improvement circuit, such as TBC, the
images may be distorted or may not be
output. In this case, set the image
improvement circuit function to off.
• The resolution of the signals output to the
COMPONENT VIDEO MONITOR OUT
jacks is converted up to 1080i. The
resolution of the signals output to the HDMI
TV OUT jack is converted up to 1080p.
• COMPONENT VIDEO MONITOR OUT
jacks have restrictions on resolution when
the resolution of video signals protected by
copyright technology is converted.
Resolution of up to 480p/576p can be output
to the COMPONENT VIDEO MONITOR
OUT jacks. The HDMI TV OUT jack has no
restriction on resolution.
• Video signals for which the resolution has
been converted cannot be output from the
COMPONENT VIDEO MONITOR OUT
jacks or the HDMI TV OUT jack
simultaneously. The video signals are output
from the HDMI TV OUT jack when both are
connected.
• Set “Resolution” to “Auto” or “480i/576i” in
the Video Settings menu to output the video
signals from the MONITOR VIDEO OUT,
COMPONENT VIDEO MONITOR OUT
jacks when both are connected.
• Converted HDMI image output does not
support x.v.Color (x.v.Colour), Deep Color
(Deep Colour) and 3D image.
To connect a recording
component
When recording, connect the recording
component to the VIDEO OUT jacks of the
receiver. Connect cords for input and output
signals to the same type of jack, as VIDEO
OUT jacks do not have an up-conversion
function.
Note
Signals output from the HDMI TV OUT or
MONITOR OUT jacks may not be recorded
properly.
HDMI TV OUT COMPONENT VIDEO
MONITOR OUT MONITOR VIDEO OUT
HDMI IN* a––
VIDEO IN aa a
COMPONENT VIDEO IN aa a
INPUT jack
OUTPUT jack