53
Other Operations

Setting up the 2 way remote

This receiver is shipped from the factory with the 2 way
remote control system set to “ON”. Normally, you can use
the receiver as is.
However, if you want to use this receiver together with
another component that is also compatible with the 2 way
remote control system, be sure to perform the following
operation to limit response to signals sent from the remote
controls.
To use with the TA-E9000ES
Perform the following steps to turn OFF this unit’s 2 way
remote control system. Also, be sure the TA-E9000ES is
turned on when using this unit.
To use with other components that have the
logo
Turn OFF the other component’s 2 way remote control
system. For details, refer to the operating instructions
suppled with your other components.
To use with Sony CD players CDP-CX260 or CDP-
CX88ES
Turn OFF the remote control adapter switch on the
CDP-CX260 or CDP-CX88ES. For details, refer to the
operating instructions suppled with the CDP-CX260 or
CDP-CX88ES.
Also when using several 2 way remote control system
components together, be sure to place them close together
in order to enable proper remote operation.
1Press SET UP.
2Press the cursor buttons ( or ) to select “2 WAY
REMOTE”.
3Turn the jog dial to select “ON” or “OFF”.

Selecting the command mode of the

remote

Change the command mode of the receiver and the
supplied remote (RM-LJ304) from its default “AV1”
setting to “AV2” in the following cases:
• When you want to change the output from the 2ND AV
jacks using RM-US104 in the 2nd room (STR-V444ES
only).
• When you want to use 2 Sony receivers in the same
room with the remote.
1Press SET UP.
2Press the cursor buttons ( or ) to select
“COMMAND MODE”.
3Turn the jog dial to select “AV1” or “AV2”.
Notes
• When you change the command mode of the receiver to “AV2”,
be sure to change the command mode of the supplied remote
(RM-LJ304) to “AV2”. For details, see the operating instructions
for the supplied remote (RM-LJ304).
• For details on how to use RM-US104, see the operating
instructions for the supplied remote (RM-US104).

Selecting the color of the on-screen

display

Select the color of the on-screen display. You can
select either “COLOR” or “MONOCHROME”. The color
of the on-screen display is set to “COLOR” by default.
1Press SET UP.
2Press the cursor buttons ( or ) to select “OSD
COLOR”.
3Turn the jog dial to select “COLOR” or
“MONOCHROME”.