Getting Started
WARNING
To prevent fire or shock hazard, do not expose the unit to rain or moisture.
IMPORTANT: never connect two mains leads into a single mains plug.
Precautions
On safety
•Should any solid object or liquid fall into the cabinet, unplug the amplifier and have it checked by qualified personnel before operating it any further.
•Because the amplifer emits heat during operation, do not place any other components on top of this unit.
On placement
•Place the amplifier in a location with adequate ventilation to prevent heat
•Do not place the amplifier near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock.
•Do not place anything on top of the cabinet that might block the ventilation holes and cause malfunctions.
To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.
Do not install the appliance in a confined space, such as a bookcase or built in cabinet.
If the power switch is kept depressed, you can turn on and off the components by only pressing the SYSTEM POWER switch on the remote.
The mains lead plug of
Do not connect this plug to any other system or mains supply.
On power sources
•Before operating the amplifier, check that the operating voltage is identical with your local power supply. The operating voltage is indicated on the nameplate at the rear of the amplifier.
•This unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off.
•If you are not going to use the amplifier for a long time, be sure to disconnect the amplifier from the wall outlet. To disconnect the mains lead, grasp the plug itself; never pull the cord.
•The AC power cord must be changed only at the qualified service shop.
•The mains switch is located on the front exterior.
On operation
•Before connecting other components, be sure to turn off and unplug the amplifier.
On cleaning
•Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine.
If you have any question or problem concerning your amplifier, please consult your nearest Sony dealer.
2EN
