Turn the jog roller to set the value.
Press the jog roller to select an item to be changed.
Set TCP/IP Config.

The IP Address, Netmask, Gateway, and DNS have been set at the factory, but you can change them as required.

1

2 Press the jog L or R button to select the digit to be changed.

3

4 Press the select R button when you are finished settings.The set values are stored.

To cancel the set values, press the select L button. To retrieve the default settings, select Default.

Calibrate Touch Panel

Touch the center of the crosshairs displayed on the touch panel with a pen or fingertip. The relationship between the screen and touched position is calibrated.

To calibrate from the beginning again, touch the center of the screen. Then the previous operation is canceled, and you can start the calibration from the beginning.

Scribble Test

You can check the operation status of the touch panel by scribbling. Scribble on the screen with a pen, and the trace will be shown.

Self Diagnosis

The operation of the jog roller, jog buttons, function buttons, and control knobs can be checked.

Installation of the Operation Software

The UCP-8060 is shipped with the operation software for several products installed. If you wish to use another product, install the operation software for the product following the procedures below. It is also necessary to install operation software when you update the system files.

You can install the operation software using a Memory Stick or via the Internet (HTTP server).

To obtain the operation software, consult your Sony representative.

Note

The memory capacity to store the operation software is limited. You may remove some operation software when you intend to install a new software.

For details on removing software, see “Removing the Operation Software” on page 36.Requirements

•Computer (to enable copying files to a Memory Stick if a Memory Stick is to be used)

•Operation software to be installed (two files, with the extension, “jar” and “jad”)

Installation using a Memory Stick• Memory Stick

Preparations

1 Copy the operation software to a Memory Stick or to an HTTP server using a computer.

To copy onto a Memory Stick, prepare a folder named MSSONY/PRO/UCP, and copy to a folder under UCP.

2 Turn the UCP-8060 On.The Main Screen appears.

For details on the IP address of the HTTP server and the network connection, consult your network administrator.

Installation of the Operation Software

33