5 Press the select R button (Save).

The Menu display appears.

The following procedures depend on whether operation software has been installed or not.

If operation software has been installed.

1 Select Install by turning the jog roller.

2 Press the select R button (Enter).

The Install display appears.

3 Touch the keyboard icon on the task bar.

The keyboard appears on the screen.

4 Enter the URL address that contains the operation software to be installed and the filename of the operation software, then press the select R button (OK).

Note

Be sure to enter the filename of the operation software with the extension “jad.”

5 Press the select R button (Go).

Information on the operation software to be installed appears.

6 If the displayed information is correct, press the select R button (Yes).

Installation begins. While reading and writing data, the status indicator is lit or blinking.

When installation is completed, a message to indicate this appears on the screen.

Note

While reading and writing data, never turn the power of the UCP-8060 Off, or remove the installed Memory Stick. The file may be damaged.

7 Press the select R button (Restart).

The Main Screen appears. Check that the name of the installed operation software appears.

If operation software has not been installed.

1 Press the select L button (Back). The Main Screen appears.

2 Press the select R button (Install). The Install display appears.

3 Touch the keyboard icon on the task bar.

The keyboard appears on the screen.

4 Enter the URL address for the operation software to be installed, and the file name of the operation software, then press the select R button (OK).

Note

Be sure to enter the filename of the operation software with the extension “jad.”

5 Press the select R button (Go).

Information on the operation software to be installed appears.

6 If the displayed information is correct, press the select R button (Yes).

Installation begins. While reading and writing data, the status indicator is lit or blinking.

When installation is complete, a message to indicate this appears on the screen.

Note

While reading and writing data, never turn the power of the UCP-8060 Off, or remove the installed Memory Stick. The file may be damaged.

7 Press the select R button (Restart).

The Main Screen appears. Check that the name of the installed operation software appears.

Setting the URL address

1 Select “http://” with the jog roller, and push the jog roller.

2 Touch the keyboard icon on the task bar.

The keyboard display appears on the screen.

3 Enter the URL address for the operation software to be installed.

4 Press the select L button (OK).

The Install Settings display appears.

Installation of the Operation Software

35