Placing horizontally

If the camera is to be put on a flat and stable place, such as on the CRT display, the computer, etc., do the following:

1

2

Turn the arm and arm plate towards you.

Put the camera on a stable surface.

Removing the camera

Note

When your computer is off, you do not need to perform step 1 below. However, if you disconnect the USB cable while your computer is in power-saving mode, and then connect it again, the camera may not be detected.

1 Close the software used by the camera.

2 Pull out the USB cable from your computer, and then remove the camera.

Note

If you pull on the cable itself when disconnecting the USB cable, you may damage the cable. Make sure that you hold onto the connector when disconnecting the cable.

7