Scotts S1642, S1742, S2046 Service Electrical, Checking the Battery, Clean Battery and Terminals

Models: S1642, S1742, S2046

1 72
Download 72 pages 50.74 Kb
Page 45
Image 45
SERVICE ELECTRICAL

SERVICE ELECTRICAL

Checking the Battery

￿CAUTION: Avoid injury! Sulfuric acid in battery electrolyte is poisonous. It is strong enough to burn skin, eat holes in clothing, and cause blindness if splashed into eyes. Wear eye protection and avoid spilling or dripping electrolyte.

Flush eyes with water for 15-30 minutes if acid is splashed into eyes.

If acid is swallowed, get medical attention immediately.

DO NOT attempt to open, add fluid or service battery. Any attempt to do so will void warranty and lead to possible injury.

B

C

A

M96453

2.Remove rubber hold-down strap (A).

3.Disconnect negative (–) battery cable (B).

4.Remove red cover (C) from positive (+) battery terminal. Remove positive (+) cable from battery.

5.Remove battery.

6.Install the battery following these steps in reverse order. (See Connect the Battery in the Assembly section.)

Clean Battery and Terminals

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge, if necessary, at 6–10 amperes for 1 hour. (See Charging the Battery in this section.)

Removing and Installing the Battery

￿CAUTION: Avoid injury! Always remove negative (–) battery cable first, and install it last, to prevent electrical short circuit to chassis.

1.Turn ignition key off and raise seat.

￿CAUTION: Avoid injury! Battery gas can explode, to avoid injury:

-Keep sparks and flames away from batteries. Use a flashlight to check battery electrolyte level.

-Never check battery charge by placing a metal object across the posts. Use a voltmeter or hydrometer.

-Always remove grounded (-) battery clamp first and replace it last.

1.Turn ignition key off and raise seat.

Service Electrical - 41

Page 45
Image 45
Scotts S1642, S1742, S2046 manual Service Electrical, Checking the Battery, Clean Battery and Terminals