OPERATING MOWER
4.Adjust gage wheels to match cut height desired. (See Adjusting Mower Gage Wheels below.)
Adjusting Mower Gage Wheels
CAUTION: Avoid injury! Before you adjust gage
wheels: STOP engine, remove key, and wait for blades to STOP.
IMPORTANT: Avoid damage! Mower gage wheels must not ride on ground to support mower weight. Adjust gage wheels each time you change cutting height.
1.Check tractor tire pressure. Inflate tires to the correct pressure. (See Checking Tire Pressure in Service - Miscellaneous section.)
2.Raise mower lift lever to TRANSPORT (upper) position and adjust cutting height. (See Adjusting Cutting Height in this section.)
D |
|
C | A |
| |
| B |
| M88571 |
3.Remove bolt (A), bushing (B), washer (C), and nut (D).
4.Move lift lever down to desired MOWING position.
5.Move mower gage wheels, one on each side, to one of four holes for desired position. On
6.Bottom of gage wheels should be approximately
7.Install bolt and tighten with nut.
Adjusting Mower Level (Side-to-Side)
CAUTION: Avoid injury! Before you adjust
mower: STOP engine, remove key, and wait for blades to STOP.
Be careful, sharp edges on mower blades. Always wear gloves when handling mower blades.
NOTE: A deck leveling gauge (Part Number TY15272) to aid in deck leveling may be obtained through your local Authorized Service Center at a nominal cost.
1.Park tractor on a hard, level surface.
2.Stop engine and remove key.
3.CHECK: Tire pressures must be correct. (See Checking Tire Pressure in Service – Miscellaneous section.)
4.Adjust cutting height to middle position.
AA
5.Turn left blade parallel to tractor axle. Hold drive belt and turn right blade parallel to axle.
A
M40161
6.Measure from each outside blade tip (A) to the level surface. The difference between measurements must not be more than 3 mm (1/8 in).
Operating Mower - 17