Scotts S1642, S1742, S2046 Using Booster Battery, Replacing Headlight Bulb, Service Electrical

SERVICE ELECTRICAL

2.	Connect positive (+) charger cable to positive (+) battery
terminal.
3.	Connect negative (–) charger cable to negative (–)
battery terminal.
4.	Plug in charger cord.
5.	Charge battery using a 12 Volt battery charger at a rate
of 6–10 amperes for a minimum of 1 hour and no more than

￿CAUTION: Avoid injury! The battery produces a flammable and explosive gas. The battery may explode:

•DO NOT attempt to jump start a frozen battery. Warm to 16 degrees C (60 degrees F).

•DO NOT smoke near battery.

•Wear eye protection and gloves.

•Keep sparks and flames away.

•DO NOT connect the negative (-) booster cable to the negative (-) terminal of the discharged battery. Connect at a good ground location away from the discharged battery.

F

2 hours.
6.	Unplug charger cord. Remove charger cables.
7.	Install battery. (See Removing and Installing Battery in
this section.)

Using Booster Battery

D

B

E	C
	A

A- Booster Battery

B- Disabled Vehicle Battery

1.Connect positive (+) booster cable to booster battery (A) positive (+) post (C).

2.Connect the other end of positive (+) booster cable to the disabled vehicle battery (B) positive (+) post (D).

3.Connect negative (–) booster cable to booster battery negative (–) post (E).

4.Connect the other end (F) of negative (–) booster cable to a metal part of the disabled machine frame away from battery.

5.Start the engine of the disabled machine and run machine for several minutes.

6.Carefully disconnect the booster cables in the exact reverse order: negative cable first and then the positive cable.

Replacing Headlight Bulb

1. Lift hood.

Service Electrical - 43