Checking and Cleaning Air Cleaner Elements - S1642 and S1742

SERVICE ENGINE

cloth.

8.Lightly oil filter gasket with fresh, clean oil.

9.Install replacement oil filter. Turn oil filter to the right (clockwise) until rubber gasket contacts filter adapter. Tighten filter an additional one-half turn.

10.Remove dipstick (B) and refill with new oil of recommended grade. (See Engine Oil in this section.)

11.Check oil level. For correct procedure see Checking Oil Level in this section.

12.Oil level must be between ADD and FULL marks. Do not overfill.

13.Install and tighten dipstick. Lower hood.

14.Start engine and check for oil leaks. Correct any leaks before operating.

15.Run engine at idle for 30 seconds. Stop engine. Wait 30 seconds and check oil level.

16.If necessary, add oil to bring level to FULL mark on dipstick.

Checking and Cleaning Air Cleaner Elements - S1642 and S1742

NOTE: It may be necessary to check the air filter more frequently if operating vehicle in dusty conditions.

1.Lift hood.

2.Clean any dirt and debris from the air cleaner before removing cover.

A

3. Remove cover (A).

S1742S1642

D1

D

B

D

BS1742S1642NOTE: DO NOT wash paper element. C

4.Inspect foam precleaner (B) and element (C) without removing.

5.If precleaner (B) is dirty, carefully remove from filter, leaving element (C) in the air cleaner housing.

NOTE: DO NOT wash paper element.

6.Wash precleaner (B) in a solution of warm water and liquid detergent.

7.Rinse precleaner thoroughly. Squeeze out excess water in a dry cloth until precleaner is completely dry.

8.Put approximately 30 ml. (1 oz.) of clean engine oil onto precleaner. Squeeze precleaner to distribute oil evenly. Squeeze out excess oil with a clean cloth.

Service Engine - 29

Page 33
Image 33
Scotts S1642, S1742, S2046 manual Checking and Cleaning Air Cleaner Elements - S1642 and S1742, S1742S1642, Service Engine