OPERATING MACHINE
A |
M96454 |
Picture Note: Model with capscrew adjuster used for illustration.
2.Loosen two cap screws (A) two turns.
3.Slide forward or rearward on mounting bracket to desired position.
4.Tighten cap screws or knobs.
5.Lower seat.
Using Slide Adjuster (S2046)
1. Pivot seat forward on its mounting bracket.
B |
2.Pull pin (B) and rotate pin to the locked position.
3.Slide seat forward or rearward to desired position.
4.Release pin, make sure pin engages in hole in frame.
Using the Park Brake
CAUTION: Avoid injury! Always LOCK park brake before getting off tractor or leaving tractor unattended.
LOCKING PARK BRAKE:
A
B
1.Push and hold foot pedal (A) all the way down.
2.Move park brake lever (B) forward, then to the left to lock position.
3.Remove foot from pedal. Pedal should not return to the up position.
UNLOCKING PARK BRAKE
1.Push and hold foot pedal (A) all the way down.
2.Move park brake lever (B) to the right, then to the rear.
3.Remove foot from pedal. Pedal should return to the up position.
Starting Engine
CAUTION: Avoid injury! Start engine ONLY outdoors or in a well ventilated place. Exhaust fumes are dangerous.
IMPORTANT: Avoid damage! Do not operate starter more than 20 seconds at a time, or you may damage it. If engine does not start: Wait two minutes before you try again. See Troubleshooting section.
NOTE: Engine will not start unless: PTO lever is DISENGAGED, park brake is LOCKED or brake/clutch pedal is pushed down. On GEAR model: The transmission shift lever should be in N (NEUTRAL) position.
Operating Machine - 7