Adjusting Brakes - Automatic Hand Control

SERVICE STEERING AND BRAKES

A

C

D

FB B

D

Brake disc (A) is contacting the case (B),

AND/OR

Brake lever (C) is contacting its mounting bracket (D), top or bottom.

If so, REPLACE friction pucks and brake disc BEFORE making adjustment. (See you Authorized Service Center.)

3.Block the front and rear wheels, and release the parking brake.

E

G

F

H

4.From the rear of the tractor, locate the brake disc (E), lock nut (F), and friction puck (G).

5.Insert a 0.25 mm (0.010 in.) shim gauge (H) between the disc and friction puck. The shim should slide with slight interference.

IF THE SHIM WILL NOT FIT:

Loosen lock nut (F) until the shim slides in. Tighten the lock nut until the shim has slight interference.

Remove the shim and cycle the brake pedal. Readjust if needed.

IF THE SHIM SLIDES FREELY:

Install the shim and tighten lock nut (F) until there is slight interference.

Remove the shim and cycle the brake pedal. Readjust if needed.

Adjusting Brakes - Automatic Hand Control

￿CAUTION: Avoid injury! Before adjusting

brakes: STOP engine. Remove key. Wait for all moving parts to STOP.

1.Park tractor on flat, level surface. STOP engine, turn key to the OFF position, and remove key.

2.UNLOCK the park brake and release brake pedal.

E

A

 

B

 

 

 

C

 

 

 

 

 

 

 

 

 

3.Measure distance from inside of brake rod stop tabs (A) to outside of compression spring bracket (B) (located below foot tread area on left-hand side of transmission). Distance

(C) should be 2 – 10 mm (0.08 – 0.40 in).

Service Steering and Brakes - 34

Page 38
Image 38
Scotts S1642, S1742, S2046 manual Adjusting Brakes - Automatic Hand Control, Service Steering And Brakes