G

SERVICE STEERING AND BRAKES

G

D

F

4.If distance is less than or equal to 2 mm (0.08 in):

Gradually adjust jam nuts (D) until specified measurement is obtained.

Depress brake pedal and LOCK park brake.

Measure the distance between edge of compression spring bracket and front edge of brake rod stop tabs. Gap should have a minimum distance of 2 mm (0.08 in).

Check brake rod compression spring (E). It should not be completely compressed when park brake is locked. A slight air gap should be visible between the coils when proper adjustment is reached.

Recycle park brake a few times and measure distances each time until specified measurements are obtained.

Brake lever (F) travel should not exceed 30° (G). If it does, measure brake components individually.

SPECIFICATIONS:

Spring bracket to stop tabs (minimum): 2 mm (0.08 in)

Brake lever travel (maximum): 30°

Adjusting Brakes - Automatic Foot Control

￿CAUTION: Avoid injury! Before adjusting

brakes: STOP engine. Remove key. Wait for all moving parts to STOP.

1.Park tractor on flat, level surface. STOP engine, turn key to the OFF position, and remove key.

2. LOCK the park brake.

Adjusting Brakes - Automatic Foot Control CManual backgroundManual background

A

D

 

B

3.Measure distance of the compressed brake spring from bracket (A) to washer (B) (located below foot tread area on left-hand side of transmission). Distance (C) should be 42-43 mm (1.65 - 1.69 in).

If distance (C) is greater than 43 mm (1.69 in) or less than 42 mm (1.65 in), gradually adjust nut (D) until specified measurement is achieved.

Service Steering and Brakes - 35

Page 39
Image 39
Scotts S1642, S1742, S2046 manual Adjusting Brakes - Automatic Foot Control, Service Steering And Brakes, G D F