Control Panel

RESET

MENU

POWER

 

 

 

 

 

INPUT

ENTER

APA

VOLUME

–+

LAMP/COVER

FAN/TEMP

POWER SAVING

ON/STANDBY

1I / 1 (on/standby) key

Turns on and off the projector when the projector is in standby mode. The ON/ STANDBY indicator lights in green when the power is turned on.

When turning off the power, press the I / 1 key twice following the message on the screen, or press and hold the key for about one second.

For details on steps for turning off the power, see “To turn off the power” on page 24.

2INPUT key

Selects the input signal. Each time you press the key, the input signal switches as follows:

INPUT A tVIDEO t S VIDEO

t

3APA (Auto Pixel Alignment) key

Adjusts a picture clearest automatically while a signal is input from a computer.

4VOLUME +/– keysAdjust the volume of the built-in speakers.+ : Increases the volume.–: Decreases the volume.
5Indicators•LAMP/COVER: Lights up or flashes under the following conditions:

–Lights up when the lamp has reached the end of its life or becomes a high temperature.

–Flashes when the lamp cover or air filter cover is not secured firmly.•FAN/TEMP (Temperature): Lights up or flashes under the following conditions:–Lights up when temperature inside the projector becomes unusually high.–Flashes when the fan is broken.

•POWER SAVING: Lights up when the projector is in power saving mode. When POWER SAVING in the SET SETTING menu is set to ON, the projector goes into power saving mode if no signal is input for 10 minutes. Although the lamp goes out, the cooling fan keeps running. In power saving mode, any key does not function for the first 30 seconds. The power saving mode is canceled when a signal is input or any key is pressed.

•ON/STANDBY: Lights up or flashes under the following conditions:

–Lights in red when a AC power cord is plugged into a wall outlet. Once in standby mode, you can turn on the projector with the I / 1 key.

–Lights in green when the power is turned on.

–Flashes in green while the cooling fan runs after the power is turned off with the I / 1 key. The fan runs for about 90 seconds after the power is turned off.

The ON/STANDBY indicator flashes quickly for the first 30 seconds. During this time, you cannot light up the ON/STANDBY indicator with the I / 1 key.

For details on the LAMP/COVER and the FAN/TEMP indicators, see on page 35.

Overview

Location and Function of Controls 11 GB