Sony VPL-CS2 Sound, Remote Commander

Symptom	Cause and Remedy
On-screen display does not	• STATUS in the SET SETTING menu has been set to OFF.
appear.	c Set STATUS in the SET SETTING menu to ON (see page 30).
Color balance is incorrect.	• Picture has not been adjusted properly.
	c Adjust the picture (see page 27).
	• Projector is set to wrong color system.
	c Set COLOR SYS in the PICTURE CTRL menu to match the
	color system being input (see page 27).
The picture is too dark.	• Contrast or brightness has not been adjusted properly.
	c Adjust the contrast or brightness in the PICTURE CTRL menu
	properly (see page 27).
The picture is not clear.	• Picture is out of focus.
	c Adjust the focus (see page 23).
	• Condensation has occurred on the lens.
	c Leave the projector for about two hours with the power on.
The picture appears too	• SHIFT in the INPUT SETTING menu has not been adjusted
small on the screen.	properly.
	c Adjust SHIFT in the INPUT SETTING menu properly (see
	page 28).
The picture flickers.	• DOT PHASE in the INPUT SETTING menu has not been adjusted
	properly.
	c Adjust DOT PHASE in the INPUT SETTING menu properly
	(see page 28).

Sound

Symptom	Cause and Remedy
No sound.	• Cable is disconnected or the connections are wrong.
	c Check that the proper connections have been made (see page
	16).
When sound is input	• Monaural sound is being input through the AUDIO connector.
through AUDIO connector,	c Input stereo sound.
sound comes through one
channel only.

Remote Commander

Symptom	Cause and Remedy
The Remote Commander	• The Remote Commander batteries are dead.
does not work.	c Replace with new batteries (see page 14).
	• The front/rear remote control detector is near the fluorescent lamp.
	c Change the setting of SIRCS RECEIVER in the SET SETTING
	menu (see page 30).
The joystick, R CLICK, or	• The mouse port on the computer does not recognize the mouse
L CLICK key does not	cable.
function.	c Restart the computer.

GB 34 Troubleshooting