BMaintenance
MaintenanceReplacing the Lamp

When it is time to replace the lamp, replace the lamp promptly with a new LMP-C120 Projector Lamp.

Note

For safety sake, do not loosen any other screws.

3 Loosen the screw on the lamp unit with the Phillips screwdriver. Pull out the lamp unit by the handle.

When replacing the lamp after using the projector

Turn off the projector, then unplug the power cord.

Handle 3

1

Wait for at least an hour for the lamp to cool.

Caution

The lamp becomes a high temperature after turning off the projector with the I / 1 key. If you touch the lamp, you may scald your finger. When you replace the lamp, wait for at least an hour for the lamp to cool.

1 Place a protective sheet (cloth) beneath the projector. Turn the projector over so you can see its underside.

Note

Be sure that the projector is stable after turning it over.

2 Open the lamp cover by loosening a screw with the Phillips screwdriver (supplied with the LMP-C120 Projector Lamp).

2

4

Insert the new lamp all the way in until

Maintenance

 

it is securely in place. Tighten the screw. Fold up the handle.

2

3 1

Notes

•Be careful not to touch the glass surface of the lamp.

•The power will not turn on if the lamp is not secured properly.

5 Close the lamp cover and tighten the screws.

Maintenance 31 GB