To adjust the tilt of the installation surface

If the projector is installed on an uneven surface, use the adjusters to keep the projector level.

Turn to adjust

Adjusters

Notes

•Be careful not to let the projector down on your fingers.

•Do not push hard on the top of the projector with the adjuster extended.

It may cause a malfunction.

Turning Off the

Power

1 Press the ?/1 key.

“POWER OFF? Please press ?/1 key again.” appears to confirm that you want to turn off the power.

Note

The message disappears if you press any key other than the ?/1 key, or if you do not press any key for five seconds.

2 Press the ?/1 key again.

The ON/STANDBY indicator flashes in green and the fan continues to run to reduce the internal heat. Also, the ON/ STANDBY indicator flashes quickly. During this time, you will not be able to light up the ON/STANDBY indicator again with the ?/1 key.

3 Unplug the AC power cord from the wall outlet after the fan stops running and the ON/STANDBY indicator lights in red.

When you cannot confirm the on- screen message

When you cannot confirm the on-screen message under certain conditions, you can turn off the power by holding the ?/1 key for about one second instead of the steps 1 and

2above.

Note

The internal circuitry of the Off & Go and Direct Power On/Off functions may cause the fan to continue to operate for a short time even after the ?/1 key is pressed to turn off the power and the ON/STANDBY indicator changes to red.

Picture the Projecting

Turning Off the Power 21