BMaintenance

Replacing the Lamp

The lamp used as a light source is a consumable product. Thus replace this lamp with a new one in the following cases.

•When the lamp has burnt out or dims

•“Please replace the Lamp and clean the Filter.” appears on the screen.

•The LAMP/COVER indicator flashes in red. (Repetition rate of 3 flashes)

The lamp life varies depending on conditions of use.

Use an LMP-F270 Projector Lamp as the replacement lamp.

Use of any other lamps than the LMP-F270 may cause damage to the projector.

Caution

The lamp remains hot after the projector is turned off with the ?/1 key. If you touch the lamp, you may burn your finger. When you replace the lamp, wait for at least an hour for the lamp to cool.

Notes

•If the lamp breaks, consult with qualified for personal.

•Pull out the lamp by holding the knob. If you touch the lamp, you may be burned or injured.

•When removing the lamp, make sure it remains horizontal, then pull straight out. Do not tilt the lamp. If you pull out the lamp while it is tilted and if the lamp breaks, the pieces may scatter, causing injury.

1 Turn off the projector, and disconnect the AC power cord from the AC outlet.

Note

When replacing the lamp after using the projector, wait for at least an hour for the lamp to cool.

2 Open the lamp cover by loosening the three screws with a Phillips screwdriver.

3 Remove the lamp cover by lifting it forward with the fingers placed on the slit of the projector.

4 Loosen the two screws on the lamp unit with the Phillips screwdriver (a), hold the knob (b), then pull out the lamp unit.

5 Insert the new lamp all the way in until it is securely in place (a). Tighten the two screws (b).

40 Replacing the Lamp