Notes
• Be careful not to touch the glass surface of the lamp.
• The power will not turn on if the lamp is not secured properly.
• When attaching the lamp, be careful not to overtighten the screws.
7 Close the lamp cover and tighten the screw.
Note
Be sure to attach the lamp cover securely as it was. If not, the projector cannot be turned on.
8 Turn the projector back over.
9 Connect the power cord and turn the projector to standby mode.
10Press the following keys on the control panel in the following sequence for less than five seconds: RESET, <, ,,
ENTER.
Caution
Do not put your hands into the lamp replacement spot, or not fall any liquid or object into it to avoid electrical shock or fire.
Disposal of the used lamp
For the customers in the USA
This product contains mercury. Disposal of this product may be regulated if sold in the United States. For disposal or recycling information, please contact your local authorities or Electronics Industries Alliance (http://www.eiae.org).
Insert the new lamp all the way in until it is securely in place. Tighten the two screws. Fold up the handle.
6
Cleaning the Air
Filter
The air filter should be cleaned whenever you replace the lamp.Remove all traces of dust from the outside of the ventilation holes with a vacuum cleaner. The time needed to clean the air filter will vary depending on the environment and on how the projector is used.
When it becomes difficult to remove the dust from the filter with a vacuum cleaner, remove the air filter and clean it.
1 Turn off the power and unplug the power cord.2 Place a protective sheet (cloth) beneath the projector. Turn the projector over so you can see its underside.
Note
Be sure that the projector is stable after turning it over.
3 Slide an air filter cover in the direction of the arrow and remove it.Cleaning the Air Filter 11GB