Using the Optional

Conversion Lens

You can install the following two types of lenses (optional) on the projector. For projection distances when installing the Conversion Lens, see page 58.

•VPLL-CT10 Long Focused Conversion Lens

•VPLL-CW10 Short Focused Conversion Lens

Follow the steps below to install the Conversion Lens. For details on installing the Lens, refer also to the installation manual supplied with the Lens.

1Turn off the power and disconnect the power cord.

2Remove the lens hood from the projector’s lens, and remove the lens cap from the Conversion Lens.

3Align the screw of the Conversion Lens with the thread around the lens of the projector as illustrated below.

4Turn the Conversion Lens clockwise until you hear it click.

Note

If the Conversion Lens is hard to turn, turn it slightly counterclockwise first, then turn it clockwise.

5Place a thick cloth (e.g., a cushion) beneath the projector. Place the projector face down.

Notes

•You cannot install the Conversion Lens on the projector’s lens with the Cinema Filter attached. Remove the Cinema Filter when you install the Conversion Lens.

•The optional Conversion Lens projects from the top of the projector when the Lens is installed on the projector. Before installation, place a cloth of adequate thickness beneath the

projector to keep the Lens from contact with the floor or a desk top. Otherwise, the Lens may malfunction if it receives too much pressure from the weight of the projector.

6Fasten the end of the safety wire of the Conversion Lens to the bottom of the projector using the screw supplied with the Conversion Lens (M5×8, with washer).

Note

Be sure to fasten the end of the safety wire of the Lens to the bottom of the projector.

When installing the projector on the ceiling

Be sure to fasten the end of the safety wire of the Lens to both the projector and the PSS-610 Projector Suspension Support in step 6, as illustrated below. In this case, use the screw (M5×12, with washer) supplied with the PSS-610.

First, place the PSS-610 ( 1 ) on the projector, then place the safety wire ( 2 ) on the PSS-610.

2 End of safety wire

1 PSS-610 Projector

Suspension

Support

WARNING

Be sure to use the screw (M5×12 with washer) supplied with the PSS-610. Never use the screw supplied with the Conversion Lens. If you use the screw supplied with the Lens, the Lens may fall from the projector and may cause injury.

Notes on installation of the optional Conversion Lens

•The Lens scratches easily, so when handling it, always place it gently on a stable and level surface in a horizontal position.

•Be sure not to bump the Lens on the surface of the lens of the projector.

•Avoid touching the Lens surface.

and Connections Preparations

Step 1: Installing the Projector

9 GB