This is the Internet version of the user’s guide. © Print only for private use.

Guidelines for safe and efficient use

Please read this information before using your mobile phone.

Note Important: to avoid hearing impairment, answer call or lower volume before placing this product to your ear.

Recommendations

Always treat your product with care and keep it in a clean and dust-free place.

Do not expose your product to liquid or moisture or humidity.

Do not expose your product to extreme high or low temperatures.

Do not expose your product to open flames or lit tobacco products.

Do not drop, throw or try to bend your product.

Do not paint your product.

Do not use your product near medical equipment without requesting permission.

Do not use your product when in, or around aircraft, or areas posted ‘turn off two-way radio’.

Do not use your product in an area where a potentially explosive atmosphere exists.

Do not place your product or install wireless equipment in the area above your car’s airbag.

Do not attempt to disassemble your product. Only Sony Ericsson authorized personnel should perform any service.

Antenna

Only use an antenna that has been specifically designed by Sony Ericsson for your mobile phone. Use of unauthorized or modified antennas could damage your mobile phone and may violate regulations, causing loss of performance and SAR levels above the recommended limits (see below).

Efficient use

Hold your mobile phone as you would any other phone. Do not cover the top of the phone when in use, as this affects call quality and may cause the phone to operate at a higher power level than needed, thus shortening talk and standby times.

Radio Frequency (RF) Exposure and SAR

Your mobile phone is a low-power radio transmitter and receiver. When it is turned on, it emits low levels of radio frequency energy (also known as radio waves or radio frequency fields).

Governments around the world have adopted comprehensive international safety guidelines, developed by scientific organizations, e.g. ICNIRP (International Commission on Non-Ionizing Radiation Protection) and IEEE (The Institute of Electrical and Electronics Engineers Inc.), through periodic and thorough evaluation of scientific studies. These guidelines establish permitted levels of radio wave exposure for the general population. The levels include a safety margin designed to assure the safety of all persons, regardless of age and health, and to account for any variations in measurements.

Specific Absorption Rate (SAR) is the unit of measurement for the amount of radio frequency energy absorbed by the body when using a mobile phone. The SAR value is determined at the highest certified power level in laboratory conditions, but the actual SAR level of the mobile phone while operating can be well below this value. This is because the mobile phone is designed to use the minimum power required to reach the network.

Variations in SAR below the radio frequency exposure guidelines do not mean that there are variations in safety. While there may be differences in SAR levels among mobile phones, all Sony Ericsson mobile phone models are designed to meet radio frequency exposure guidelines.

A separate leaflet with SAR information for this mobile phone model is included with the material that comes with this mobile phone. This information can also be found, together with more information on radio frequency exposure and SAR, on: www.SonyEricsson.com.

Driving

Please check if local laws and regulations restrict the use of mobile phones while driving or require drivers to use handsfree solutions. We recommend that you use only Ericsson or Sony Ericsson handsfree solutions intended for use with your product. Please note that because of possible interference with other equipment,

184 Guidelines for safe and efficient use