GoldMike MK2 9

Outputs 1/2

The preamplifier signals are f ed to these elect ronically balance d
outputs. Alternatively th e GoldMike MK2 can be equipped with
optionally available transfor mer outputs from Lundahl (see
“Lundahl Tr ansfor mers” o n page 22 ).
Since the XLR and 1/4 inch TRS connectors are wire d in parallel,
an unbalanced connection at one connector will cause unbal-
anced operation in its parallel conne ctor, e.g. if a mono 1/4 inch
plug is inserted into the 1/4 inch jack, the cor responding XLR
socket will also operate unbalanced.

GND Lift

The GND Lift switch separ ates internal ground from chassis
ground. The switch can be act ivated to eliminate ground loop
humming which may occur if the GoldMike MK 2 is connected to
units with a different ground poten tial.
The switch should normally be in the GND position to main-
tain the shielding effect of the met al housing for internal
GoldMike MK2 electronics.

Instr. Input 1/2

The Instrument input jack is place d on the front panel for easy
access. It should be used to connect instruments like E-bass,
electric guitars, acoustic guitars with pick-ups etc.
The Instrument input features a 1 MOhm (one Mega O hm) input
impedance.
IMPORTANT: As long as an instrument is plugged into front
Instrument input, the rear panel Line Input is deactivated.
Rear Panel/Connections
XLR &TRS Jack: Balanced +4dB
OUTPUTS 1
OUTPUTS 1
Use Mono Jacks for Unbal. Operation
Front Panel/Connections
INSTR.
GND LIFT
GND LIFT
GND LIFT