INSTALLATION S SERIES RESTAURANT RANGES
P
AGE
16
OF
40 O
WNER
’
S
M
ANUAL
1191904
REV
1
(11/10)
S

TEP

2

B

:
A

TTACH

C

ASTERS AND

R

ESTRAINT

NOTICE

For an appliance equipped with casters, (1) the installation shall be made with a connector that complies with
the Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connec tors for Moveable Gas
Appliances, CAN/CGA-6.16, and a quick-disconnect device that complies with the Standard for Quick-
Disconnect Devices for Use With Gas Fuel, ANSI Z21.41, or Quick Disconnect D evices for Use with Gas Fuel,
CAN1-6.9, (2) adequate means must be provided to limit the movement of the a ppliance without depending on
the connector and the quick-disconnect device or its associated piping to lim it the appliance movement, and (3)
the restraining means should be attached to a frame member on the back of the unit.
A set of four casters is packed with ranges ordered with casters (instead of le gs).
A threaded leg pad is fastened to the base frame at each corner. Each caster has a corresponding mating thread. The
casters can be adjusted to overcome a slightly uneven floor. Casters are pro vided with a fitting for proper lubrication
when required.
1. Raise range sufficiently to allow the casters to be attached. For safety, “shore up” and support the range with an
adequate blocking arrangement strong enough to support the load.
2. Screw the cas ters into the holes in the centers of the leg pads. Install the casters that have a locking brake under
the front of the range.
3. Lower range gently onto a level surface. Never drop or allow the range to fall.
4. Use a level to m ake sure that the range surface is level. The casters can be screwed in or out slightly to lower or
raise each corner of the range.
Figure 4

Installation of Casters

5. Secure the res training-device bracket (item “B” in the following illustration) to a wall stud located as close as
possible to the appliance connector inlet and outlet connections. Use four #12 s crews (items “C”) and plastic
anchors (items “A”) if necessary.
6. Install e ye-bolt (item “F”) to a frame member on the rear of the equipment. After checking carefully behind the
frame member for adequate clearance, drill a 1/4" (6 mm) hole through the fr ame member.
7. Thread hex nu t (item “G”) and slide the washer (item “H”) onto the eye-bolt. Insert the eye-bolt through the 1/4"
(6 mm) drilled hole and secure with a washer (item “H”) and nylon lock nut (item “I”).
8. Using the spr ing-loaded snap hooks, attach the restraining device to the bracket and the eye-bolt.
9. Using the ca ble clamp (item “D”), adjust the restraining device extended length to prevent over-bending or
kinking of the appliance connector.