S SERIES RESTAURANT RANGES SERVICE
O
WNER
’
S
M
ANUAL
1191904
REV
1
(11/10) P
AGE
23
OF
40
T

ROUBLESHOOTING

C

ONVECTION

-O

VEN

B

LOWER

WARNING

Before attempting to service or replace any electrical component, make sure po wer source has been
disconnected.

CAUTION

When changing motor or servicing range, always verify that blower wheel rotat ion is clockwise when looking into
the oven cavity.
If the blower does not run at all, consult the flowchart that begins on the next page. If the blower runs intermittently,
consult the flowchart on this page.
The appropriate wiring diagram for the oven can be found on the rear of the o ven (as well as at the end of this section
of this manual).
Figure 9

Convection-Oven Blower Runs Intermittently

DISCONNECT POWER AT CIRCUIT BREAKER.
Convection-oven blower runs intermittently.
Check that there are no ai
r
-
flow obstructions around the range.
Does the problem
occur only when the oven
is hot?
No
Yes
Check that the blower motor air vents are not obstructed.
Check that the blower motor is not pressing against the wall
behind the range.
Check for excessive grease and dust buildup on the motor.
Check for sources of excessive heat behind the range.
Check for hot-air leaks around the motor pocket.
Check all wiring for loose connections or breaks.
With the blower turned ON, turn the oven thermostat to OFF and
allow the oven to cool. If the blower motor runs continuously
when the oven is cool, turn the oven thermostat to the highest
setting. If the blower motor shuts off when the oven becomes hot,
and if there are no sources of excessive heat around the blower
motor, replace the blower motor.
Remove the cover from the junction box on the back of the range.
Disconnect the black wire and place an ammeter in the circuit.
CAUTION: Check that the ammeter is rated for at least 40
amperes! Reconnect the power to the range and turn on the
blower switch while watching the ammeter. The reading should
surge and then return to the rated current of the motor when
running at high speed. If the measured current exceeds the motor
rating, replace the blower motor.