Mfg. Since 10/09 | P R E P A R A T I O N |
Installation
Before installing the rotary table, make sure that the spindle centerline is properly aligned or "trammed" with the mill table. Also, remove any burrs or scratches from the mating surfaces of the rotary and mill table by "stoning" them, then thoroughly wipe them clean and dry (refer to the Surface Care section on Page 16 for detailed instructions).
Horizontal Installation
The horizontal base has slots (see Figure 3) that accept keys for quick alignment with the mill table. Because of the many variations in mill table
To mount the rotary table horizontally:
1.DISCONNECT MILL FROM POWER!
2.Position the rotary table horizontally on the mill table so that the mounting slots shown in Figure 3 are aligned with the mill table center
Make sure the rotary table handwheel is free of obstructions. Depending on your setup, the rotary table may need to be blocked up or mounted so the handle is hanging over the edge of the mill table.
3.Attach the rotary table to the mill table with the clamping hardware, but leave the fasteners loose for now.
Mounting | Key Slots | |
Slots | ||
|
Figure 3. Locations of the horizontal base key slots and mounting slots (Model SB1363 shown).
4.Place the machinist's square along the front edge of the mill table and the machined foot of the rotary table, square the rotary table to the mill table, then fully tighten the clamping fasteners.
You MUST properly secure the rotary table to the mill table to prevent unexpected movement of the rotary table and workpiece during operation, which could result in personal injury or workpiece damage.
5.Perform the Horizontal
